company news about Solution to labeling machine failure

Like other organisms, packaging machinery products also have their service life. The length of service life depends on whether the user knows how to use and maintain the equipment. Therefore, it is necessary to know some common knowledge about packaging machinery failures:

1. Label paper left on the target board. Adjust the position of the clamping jaws. The glue transition is too large. Adjust the glue temperature. Low glue on the left side of the mark will cause the marking paper to lift. Adjust the position of the mark.

2. The label paper is skewed. Adjust the height of the label box from left to right according to the position of the label paper on the target board.

3. Label paper is wrinkled and uneven. Adjust the thickness of the rubber film on the rubber roller.

4. The corners and burrs of the label paper are bent. The glue on the target plate is not evenly distributed. Adjust the position of the target plate to make the glue evenly distributed

5. The machine stops suddenly during operation. If there is a bottle that will burst the protective door, just close the protective door, whether there is no wine in the front chain channel or whether the rear chain is blocked, and whether there is a wine bottle in the labeling machine, take it out.

6. During the operation, throw away the bottle when pasting the top label. Check whether the upper and lower positions of the bottle pressing head are appropriate, adjust its position, and check whether the ball in the bottle pressing head is missing, resulting in inflexible rotation of the bottle head. Just replace it and check whether the base plate behind the

pressing plate is loose. The plastic bottle at the delivery position of the label on the rotary hub is in place and adjusted.

7. After the indenter is marked on the top, the marking paper is damaged or the top is incorrect. Replace the sponge pad and rubber spring pad in the indenter equipment.

8. Poor cosmetic effect. Check the position of the belt and adjust it to a proper position. If the cosmetic nozzle is blocked, just clean it.

9. The code is not clear and the position is not centered. Check whether there are foreign matters or water drops on the bottle cap, adjust the position of the blowpipe, check whether the nozzle is clean, flush the nozzle, and adjust the position of the nozzle to center the code.