Up to 5 files, each 10M size is supported. OK
Hangzhou SED Pharmaceutical Machinery Co.,Ltd. 86-0571-88617715 info@sedpharma.com

News

Get a Quote
Home - News - Introduction To The Operation Steps Of The Capsule Filling Machine

Introduction To The Operation Steps Of The Capsule Filling Machine

March 25, 2022

Steps:

1. Press the green button in the "power switch" to turn on the power.

2. Slowly adjust the "vibration intensity adjustment knob" and rotate it clockwise. At this time, the sorting tray integrated with the "vibration bracket" starts to vibrate. Touch the sorting tray with your hand and adjust to a certain vibration intensity by feeling.

3. Put the powder capsule shell into the "Powder Capsule Shell Arrangement Tray", and put about 300 capsules each time. Put the capsule caps into the "capsule cap sorting tray", about 300 capsules each time. The sorting plate is made of

 

plexiglass plate, and there are many round holes with large upper and lower small funnels drilled on it. The diameter of the round holes corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibrating table moves steadily forward and backward, so that the capsules enter the hole of the table one by one.

4. After about 30 seconds, the powder capsule shell and capsule cap will fall into the round hole with the opening facing upwards. If the individual openings are facing down, the capsule cap can be used to gently press down the sleeve, and then the sleeve can be pulled out.

5. Hold the connecting plate of the powder capsule shell horizontally (at the end of the picture, it has been prepared randomly, there is a round hole in the connecting plate), and push it gently in the lower part of the sorting tray, and the

 

powder capsule shell in the sorting tray will be closed. It will drop down into the round hole of the connecting plate, and then take out the connecting plate. In the same way, remove the capsule cap with the capsule cap cover plate.

6. You can prepare a square plate of medicine powder with a bottom area of ​​500×500mm and a height of about 10mm on the four sides in advance. Then cover the random plexiglass frame on the powder capsule connection board, put the powder into the frame with a small bucket shovel, and scrape the frame with the edge to fill the powder, and scrape off the excess powder.

7. Use the randomly equipped capsule cap to cover the set board (not shown in the picture, the set board has round holes), put it on the capsule cap cover plate, there are alignment holes, it is easy to place. Flip the capsule cap cover plate so that

 

the opening of the capsule faces down, and cover it on the powder capsule shell plate that has been filled with medicinal powder. There are also alignment holes, which are easy to fit.

8. Put the sleeved capsule board into the cavity below the "capsule cap forming board", and pull the "pressing rod" down by hand until it is in place. There is no need to be careful of excessive force, because there is a positioning mechanism to

 

control the downward pressure. high. Take out the sleeved capsule board, pour out the capsule, and complete the filling. The next board can be cycled.