The semi-automatic capsule filling machine is a new type of semi-automatic capsule filling machine that integrates electricity and gas, which is meticulously built for small and medium-sized pharmaceutical factories, health care products factories and hospital preparation rooms. It has a novel structure and beautiful appearance. The body and working table are made of stainless steel, and the product complies with GMP requirements; The machine adopts a programming control system, touch panel operation (V type), stepless frequency conversion adjustment, pneumatic joint control and electronic automatic counting device, which can automatically complete the actions of capsule turning, positioning, separation (cap body off), drug filling, locking, etc., with accurate filling dose and convenient operation. Suitable for capsule filling of powdery and granular drugs and health care products! It is an ideal capsule filling equipment at present.
Use method of semi-automatic capsule filling machine:
1. Press the green button in the "power switch" to turn on the power.
2. Slowly adjust the "vibration intensity adjustment knob" and turn it clockwise. At this time, the sorting disc integrated with the "vibration support" starts to vibrate. Touch the sorting disc with your hand and adjust it to a certain vibration intensity by feeling.
3. Put the powder capsule shell into the "powder capsule shell sorting tray", about 300 capsules each time. Put the capsule cap into the "capsule cap sorting tray", about 300 capsules each time. The sorting tray is made of plexiglass plate, with many large and small funnel shaped round holes drilled on it. The diameter of the round hole corresponds to the diameter of the capsule number.
4. After about 30 seconds, the powder capsule shell and capsule cap will fall into the round hole with the opening facing up.
5. Hold the connecting plate of the powder capsule shell horizontally (it has been prepared randomly, and there is a round hole in the connecting plate), push it slightly in the lower part of the sorting plate, and the powder capsule shell in the sorting plate will fall down into the round hole of the connecting plate, and then take out the connecting plate. In the same way, take out the capsule cap with the capsule cap connecting plate.
6. A powder square plate with a bottom area and four sides high can be prepared in advance, which is filled with powder, and the connecting plate of the powder capsule shell can be placed flat in the powder square plate.
7. It is easy to place the capsule cap with the matching capsule cap set plate on the capsule cap connecting plate. Turn over the connecting plate of the capsule cap, make the capsule opening face down, and cover it on the connecting plate of the powdered capsule shell that has been filled with powder. There are also alignment holes, which are easy to cover.
8. Put the sleeved capsule plate into the cavity under the "capsule cap forming plate", pull the "pressure bar" downward and put it in place with your hand, and don't worry about excessive force, because there is a positioning mechanism to control the pressing height. Take out the sleeve capsule plate and pour out the capsule.
Contact Person: Ms. Wei
Tel: 86-15372434551
Fax: 86-571-88615836