company news about Talking about the operation steps of semi-automatic capsule filling machine

The semi-automatic capsule filling machine is suitable for filling various domestic or imported capsules. This machine is controlled by electricity and gas, equipped with electronic automatic counting device, which can automatically complete the positioning, separation, filling, locking and other actions of capsules, reduce labor intensity, improve production efficiency, and meet the pharmaceutical and health requirements.

This machine is sensitive in action, accurate in filling dosage, novel in structure, beautiful in appearance and convenient in operation. It is an ideal equipment for filling capsule drugs in the pharmaceutical industry at present.

Operation steps of semi-automatic capsule filling machine:

1. Press the green button in the "Power Switch" to turn on the power.

2. Slowly adjust the "Vibration Intensity Adjustment Knob" and turn it clockwise. At this time, the finishing disk integrated with the "Vibration Support" starts to vibrate. Touch the finishing disk with your hand and adjust it to a certain vibration intensity according to your feeling.

3. Put the powder capsule shell into the "powder capsule shell finishing plate", about 300 capsules each time. Put the capsule cap into the "capsule cap sorting tray", about 300 capsules each time. The finishing tray is made of organic glass plate, and there are many funnel shaped round holes drilled on it. The diameter of the round holes corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibrating worktable moves steadily and slowly forward and backward, thus entering the hole of the worktable one by one.

4. After about 30 seconds, the capsule shell and capsule cap will fall into the round hole with the opening facing up. If the individual opening is downward, gently press the capsule cap downward to cover it.

5. Hold the connecting plate of powder loaded capsule shell horizontally (it is drawn at the end of the figure, and has been prepared at random. There is a round hole in the connecting plate). Push the lower part of the finishing plate inward slightly, and the powder loaded capsule shell in the finishing plate will fall down into the round hole of the connecting plate, and then take out the connecting plate. In the same way, take out the capsule cap with the capsule cap connecting plate.

6. A powder square plate with a bottom area and four sides high can be prepared in advance, which is filled with powder. The connecting plate of the powder capsule shell can be placed flat in the powder square plate. Then cover the randomly prepared plexiglass frame on the connecting plate of the powder loading capsule, put the powder into the frame with a small bucket, scrape with the edge of the frame to fill the powder, and scrape off the excess powder.

7. Use the capsule cap fitting plate (shown at the end of the figure, there are round holes on the fitting plate), and place it on the capsule cap connecting plate, with alignment holes, which is easy to place. Turn over the capsule cap joint plate, make the capsule opening face down, and cover it on the joint plate of the powder loaded capsule shell. There are also alignment holes, which are easy to cover.

8. Put the sheathed capsule plate into the cavity under the "capsule capping forming plate", pull the "pressure bar" down by hand and put it in place. There is no need to worry about excessive force, because there is a positioning mechanism to control the downforce height. Take out the sheathed capsule plate, pour out the capsules, and complete the filling. The next board can be cycled.