company news about Talking about the maintenance of the vacuum separator of the automatic capsule filling machine

The automatic capsule filling machine integrates machine, electricity and gas, adopts microcomputer programmable controller, touch panel operation, frequency conversion speed regulation, and is equipped with electronic automatic counting device, which can automatically complete the positioning, separation, filling and locking of capsules. and other actions, reduce labor intensity, improve production efficiency, and meet the requirements of pharmaceutical hygiene.

This machine is sensitive in action, accurate in filling dose and convenient in operation, and is suitable for filling various domestic or imported capsules. It is an economical and practical equipment for filling capsule medicines in the pharmaceutical industry.
 

The vacuum separator of the vacuum system of the automatic capsule filling machine mainly plays the role of sucking the capsule into the upper and lower modules and separating the cap and the body in the filling of the hard capsule.

If the capsule cannot be separated from the cap and the body, the subsequent filling will not be carried out. Each time the turntable of the capsule filling machine rotates at one station, the main shaft of the machine rotates once, and the vacuum separator of the capsule filling machine moves up and down once under the action of the cam.

If the capsule cap and body are not separated smoothly, check the gap between the upper plane of the vacuum separator and the lower plane of the lower module.

If the gap is too large, the vacuum degree of the vacuum system will not reach the vacuum degree required for the separation of the cap and the body.

If the gap is too small, it is easy to cause collision and deform the lower module. When the position of the vacuum separator needs to be adjusted, use the handle to turn the main motor shaft of the automatic capsule filling machine to make the vacuum separator rise to the highest position, loosen the locking nuts at both ends of the adjusting rod under the machine table, and then rotate the adjusting rod Adjust the height of the vacuum separator, then lock the nut and turn the main motor shaft with the handle until it is suitable.

The vacuum degree is read out on the vacuum gauge on the machine operation panel. When the vacuum is too high, the vacuum degree regulating valve can be opened properly, and when the vacuum is too low, the vacuum degree regulating valve can be turned off or closed.

The filter of the vacuum system of the capsule filling machine should be opened regularly to remove the blocked dirt to ensure that the vacuum system has sufficient vacuum.