Servo double-sided labeling machine can improve the sticking efficiency of product labeling and film sticking, with accurate sticking position, good quality and high stability; avoid manual labeling, low film sticking efficiency, sticking skew, blistering and wrinkling, sticking A series of problems such as irregular location; effectively reduce product cost, improve product logo aesthetics, and enhance product competitiveness.
Servo double-sided labeling machine workflow:
Core working principle: The sensor detects the passing of the product, and sends back a signal to the labeling control system. The control system controls the motor at the appropriate position to send the label and attach it to the position where the product is to be labelled.
The product flows through the labeling device, and the label is covered and attached. On the product, the attaching action of a label is completed;
The vertical labeling method is adopted, and a special positioning and top pressing device is installed to ensure the stability of the bottle body; the machine head can be adjusted up and down, front and rear, and tilt, which is suitable for labeling any irregularly shaped parts; a special pressing device is installed to ensure The label is close to the body and flat; it is tracked by a rotary encoder, and the speed of the conveyor belt can be adjusted at will, and the labeling speed is always synchronized with it.
Irregularly shaped parts are labeled; a special pressure labeling device is installed to ensure that the label is close to the body and flat; the rotary encoder is used for tracking, the conveyor belt can be adjusted at will and the speed of labeling is always synchronized with it.
Adopted man-machine interface operation, electric eye detection, PLC control, rotary encoder tracking, frequency converter speed regulation, to achieve real automation.
It is suitable for double-sided labeling of symmetrical or asymmetric flat, square, oval, cylindrical, conical and special-shaped bottles in the food, cosmetics, daily necessities and pharmaceutical industries.
Preparation before using the servo double-sided labeling machine:
1. Detect whether there are sundries in the components of the double-sided labeling machine. If there is any need to remove it, use compressed air to blow out the dust in the conveyor belt.
2. Check whether the electrical system is in good condition.
3. Before the double-sided labeling machine, make sure that there are no people or obstacles near or below the roller.
4. Before starting the double-sided labeling machine, check whether the oil level and liquid level emergency coolant in each system are normal and reliable according to the instruction manual, and check whether the screws of each connecting part are loose.
5. Check whether there are people or obstacles near and below the double-sided labeling machine.
6. Check whether the vibration switch is disconnected and whether the transmission gear is in neutral.
Contact Person: Ms. Wei
Tel: 86-15372434551
Fax: 86-571-88615836
