company news about How to solve the problem of drip leakage during the use of quantitative liquid filling machine?

If the quantitative liquid filling machine leaks, we need to do the following:

1、 Check the mechanical problems of the quantitative liquid filling machine itself to determine whether the ball valve in the quantitative liquid filling machine is damaged or not tight. If the reason is the internal ball valve, a good way to solve the problem of the quantitative liquid filling machine is to replace the internal ball valve. The internal ball valve is damaged and can only be replaced.

2、 Check whether the syringe assembly is clean. If it is not clean, it will lead to uncleanness and blockage between the inner and outer tubes. It is necessary to disassemble the syringe, clean it, and carry out disinfection and maintenance.

3、 Check whether the filling nozzle hole is complete. If the filling nozzle hole is broken, the filling machine will drip during operation. If the filler nozzle hole is broken, it is necessary to replace the filler nozzle hole, and check the use of other filler nozzle holes. If they are aging or corroded, replace them as soon as possible.

4、 Check whether the o-ring is corroded or worn. If the o-ring is corroded or worn, the filling machine will leak. Therefore, it is recommended to replace the o-ring.

5、 Check the position of the cylinder. Determine whether the charging cylinder is in the middle of the charging cylinder support. At the same time, check whether the charging cylinder piston and piston rod are firm. If they are loose, lock them. If the position of the cylinder problem changes, reinstall the cylinder to confirm the correct position.

The drip problem of the quantitative liquid filling machine is not big or small. If the drip problem of the quantitative liquid filling machine is not solved all the time, it may affect the efficiency and quality of our subsequent work.

Therefore, we should pay attention to the dripping problem of the quantitative liquid filling machine. If there is a problem, it should be repaired in time. Later, the service life of the filling machine will be improved, and the quality and quality of the products will also be improved.