company news about Common faults and adjustment skills of horizontal labeling machine

With the continuous development of the market, the demand for horizontal labeling machine equipment is increasing. Horizontal labeling machines are widely used in beverage, daily chemical, food and other industries, which reduces the difficulty of labeling in various industries, not only labeling The speed is very high and the precision is also very accurate.

It can complete one bottle with multiple labels. The emergence of the horizontal labeling machine has driven the rapid development of many industries and brought more economic benefits. Today, the editor will take you to understand the common faults and adjustment skills of the horizontal labeling machine:

1. No labels

1. The position of the electric eye for measuring the object is wrong, adjust the position of the electric eye

2. If the electric eye of the object is faulty, replace the electric eye

3. The labeling head label is not tight enough to pull the paper, adjust the pulling paper

4. System failure, check the cause of the failure

5. The power supply of the header is not connected, turn on the power supply

2. Continuous labeling

1. The position of the label electric eye is wrong, adjust the position of the electric eye

2. The label sensor is faulty, adjust or replace the label sensor

3. The axial position of the labeling is not allowed

1. The position of the peeling plate of the labeling head is not correct, adjust the handle

2. The position of the label on the labeling head is wrong, re-adjust the label position

Fourth, the labeling position is not allowed before and after

1. Adjust the front and back position of the measured object electricity or adjust the labeling delay

Five, can not stick the label

1. The bid-out speed is too slow, increase the bid-out speed

2. The reserved label is not long enough, adjust the length of the reserved label

3. The bid-out speed is too fast, adjust the bid-out speed down

4. The electric eye of the measuring object is too far from the marking end

5. The interval is too small, increase the speed of the pinch belt

6. The sticky label is poor or the object to be attached is not clean

6. Wrinkles after labeling

1. If the reserved label is too long, reduce the reserved length of the label

2. The speed of the label feeding is too fast and the speed of the pinch belt is relatively slow. Adjust the speed of the two to match.