300L Ointment Manufacturing Machine Pharmaceutical Use Vacuum Emulsifying Mixer
Main Technical Data:
|Kettle Cover||Liquid(particle)inlet, sunk material inlet, air inlet with filter, inspect light and sight glass, vacuum port, pressure meter(1 to -0.1 bar), pressure clamp|
|Mixing pot||Material||Inner layer: SUS316L thickness: 3mm|
|Middle layer: SUS304 thickness: 2mm|
|Outside layer: SUS304 thickness:2mm|
|configuration||Bottom material exhaust, size: 1.5”|
|Temp. sensor (0-199℃)|
|Electrical heating: 18kw, cooling water inlet|
1．Material: SUS316L; standard homogenizer
2. Power: 5.5kw/380/50Hz; RPM: 2900R/Min
|Stirring scrap and middle stirring||Material: SUS316L,Scrap material: PTFE|
1. Stirring scrap and middle stirring use the same motor
3. Stirring scrap and middle stirring rotating the opposite direction
|Safety: 1. During stirring, the cover can not open, 2. Cover lift can not stirring.|
1. Vacuum pump: water recycle, power 2.2kw/380V/50Hz
2. With pressure sensor (during vacuum condition, hydraulic can not open)
|Heating method||Jacket electrical heating|
|Exhaust method||Electric doom and bottom discharge or positive pressure discharge material|
|Pressure||Pressure in the pot during working: -0.090 Mpa; Jacket working pressure:0.2 Mpa|
|Control box||SUS304 , 1.2mm thickness|
The SED-300RZ material are stirred by both the center blade and side scraper, which works on the inner surface of pot keeping stirring materials from being stuck onto the wall. In the process of blade-stirring, the materials are continuously crushed, pressed, fold.
Then the material is sent to the cut-off mixing unit where they are again cut off, broken and stirring by the strong interaction between running cutting wheel and cutting sheath. The materials are finally crushed into small pellets of 200um~2um
1) The pot cover is automatic rising type, the material was directed draw into the emulsifying boiler from oil boiler and water boiler based on a pipe that is under vacuum, the discharge is based on the turn the emulsifying boiler.
And the heating system is electric heating or steam heating that the temperature is automation control. Put the cool water into the intercalated bed so cooling the material, simple operation and safety( at the outside have a warm layer).
2) The homogenizer and the blade stirring can together work or separate work.. the material sliming,emulsification,mixing,dispersing,etc. what will finished during short time.
3) Contact position adopt high-quality stainless steel (medical use adopt 316L material make with supplies, the polishing of surface of the mirror of interior surface, mix the hygiene of the device in vacuum, it accords with the normal hygiene standard manufacture of GMP to adopt that is most ideal production equipment.)