Automatic Hard Capsule Filling Machine For Capsule Size 00#-5#
Main Parameter of Capsule Filling Machine
|Size of capsule||Capsule size 00#-5# and safety capsule A-E|
|Compressed air||0.2m3/min 0.3-0.4MPa|
Trait of Capsule Filling Machine
1. It has been improved the inner design turret,and imports beeline bearings for each machine from Japan directly,so that it can be sure a longer usage-life and precision of machine.
2. The working station cam runs under the good lubricating condition,and maintains the inner lubrication of cam slot to a full extent,increasing the pressure pulverization oil pump,thus extends the operation life of the spare parts.
3. Single movement for both upper and lower segments with two-lip seal provide a much better sealing performance.
4. It is controlled by the computer,has a stepless timing with the frequency-conversion,the numeral showing makes an easy operation and clear appearance.
5. The multi-bore dosing brings a precision dosage(it is controlled around ±3.5%);The capsule qualified rate is higher than 99%.It can be filled with the Chinese traditional medicine and the Western medicine.
6. It has a protector equipment for the operator and the machine. It has an automatic pause equipment when it is lack for the material. It has a steady and safe working,it is the best choice for the hard capsule made factories.
working principle of Capsule Filling Machine
The working principle of the automatic capsule filling machine is divided into two parts, which are the movement of the capsule and the filling of the medicine:
1. Movement of the capsule
During the filling process of the intermittent capsule filling machine, the movement of the capsule depends on the indexing box for intermittent and discontinuous rotation. The filling volume of the capsule is mainly determined by the volume of the metering disc hole. The hollow capsule is in the capsule hopper, the main board moves up and down, the capsule enters the capsule
guide groove by its own gravity, and then the horizontal fork and the vertical plug are used to make the capsule cap upward and the capsule body downward into the upper and lower modules. The capsule body and capsule cap are separated under the action of the device, and then the module enters the powder filling station.
2. Drug filling
The sensor in the powder holding ring controls the screw feeding rod above it, and the medicine is continuously added to make the height of the powder in the powder holding ring constant. position, push the drug column into the capsule body. After that, it
enters into the capsule rejection, capsule locking, finished capsule discharge, and module cleaning stations in turn, and then enters a new round of station cycle, and the cycle begins again and again.
Product description of Capsule Filling Machine
The machine is an intermittent motion and hole plate type filling fully automatic capsule filling equipment. It adopts optimization design combined the characteristics of Chinese medicine and the requirement of GMP, it has the characteristics of compact mechanism, small volume, lower noise, precision filling dosage, multi-function, running stably etc.
It can finish the following motion at same time: capsule feeding, capsule separating, powder filling, capsule rejecting, capsule locking, finished capsule discharge and module cleaning etc. This machine is designed for meet the volume-produce on the basis of model NJP-1200 automatic capsule filling machine. It increases the lifting mechanism that easy to clean. It saves the cost and manpower for the enterprise that need volume-produce.
Product Show of Capsule Filling Machine
Application of Capsule Filling Machine