For the food industry, its better development is inseparable from the filling equipment of the three-in-one filling machine and the filling production line. Take the three-in-one filling machine, its successful development solves the filling problem for the daily chemical and food industries, which not only can better guarantee the product quality, but also improve the production efficiency of the enterprise.
The operation of the three-in-one filling machine before and after use is very important, which is the key to the installation, commissioning, use and maintenance of the filling machine. This is the basic work related to the quality and efficiency of the filling machine manufacturer.
First of all, before the three-in-one filling machine is used, it must be installed and then debugged. Read the instructions carefully before commissioning to prepare the tools used. After the filling machine is installed, the filling rail and the bottle receiving tray are leveled, the liquid storage tank is filled with materials, and all the electrical switches are in the closed position. Insert the container to be filled into the tool box, connect the external power supply, the power socket must be a three-pin socket, and have a reliable grounding wire to prevent the machine from leaking power, turn the machine power switch to ON, and the power indicator light. Use the three-in-one filling machine to fill the support frame and hold the filling frame. Point the hand to the positioning sleeve on the top filling head. The positioning sleeve should be able to move up and down flexibly. The filling needle is exposed or retracted. No obstacles. Turn the switch under the liquid storage tank to the open position, so that the material can flow into the total metering pump. According to the total filling amount of each container, adjust the screw on the crank and rotate the knob of the filling speed control board to about 20 degrees. Then turn the switch on the filling speed control board to the open position.
After using the three-in-one filling machine, pay attention to its maintenance. When removing and removing the piston during maintenance, remove the fixing screws at the same time to avoid affecting the other process requirements when the first one is removed. Before the piston filler is cleaned, the remaining product should be removed and the tank filled with a mild cleaning solution. The cylinder has been lubricated at the factory. Please do not open or add any lubricating oil to ensure that the surface of the filling machine is clean and hygienic. In addition, while insisting on the maintenance and proper use of the filling machine, it is necessary to carry out regular inspection and debugging. Only in this way can the filling machine be able to work healthily and stably.